NEC NEAX 2000 IVS Command Manual page 98

COMMAND CODE
08
BASIC SERVICE FEATURE
149 In delay-type paging, when the paged party encounters a busy
paging circuit, Call Back is automatically set. (Applicable to
both Radio Paging and Speaker Paging.)
150 Restriction of a station to station call between tenants by
CM63 Y=1 is temporarily cancelled by external key.
151 Dialing 1 for switch hook flash (DP Telephone) / switch hook
flash (DTMF / DP Telephone).
153 Howler Tone sent to locked-out stations.
155 When a station user dials the digit "1" upon encountering a
trunk busy.
156 Dialing of a Single Digit Feature Access Code while the call-
ing station hears RBT or performs a Voice Call.
157 Whether the Paging Answer code and the Paging Access code
are to be the same or not.
If codes are the same, paging access codes must be set to trunk
routes (in CM30 YY=00), as follows:
Paging Answer Zone 0 :
CM20, 1st data=070 – 079, are used to set the combined
access/answer codes.
158 All Zone Internal Paging.
161 Transfer a trunk line placed in Consultation Hold. (Hold
Transfer)
162 If the multiple Radio Paging access is available after access-
ing a Radio Paging Trunk with delay type Radio Paging.
163 Step Call for an Incoming Call from a Tie Line.
165 Replaying of a message recorded in the Digital Announce-
ment Trunk for Attendant Delay Announcement.
168 When the DTMF station or Multiline Terminal station dials
"#" during the setting of Station Speed Dialing feature.
TITLE:
BASIC SERVICE FEATURES
Trunk Route 50
9 : Trunk Route 59
ND-45669 (E)
Addendum-002
JANUARY, 1999
SETTING DATA
0 To set
1 Not set
0 To cancel
1 Not cancelled
0 Not available
1 Available
0 Not sent
1 To send
0 Switch Hook Flash
1 Ineffective
0 To allow
1 Not allowed
0 Same
1 Different
0 Not available
1 Available
0 Available (Hold Transfer)
1 Not available (Consultation Hold)
0 Not available
1 Available
0 Not available
1 Available
0 The message is replayed at an interval.
(See CM41 Y=0, Function No. 47)
1 The message is replayed only once.
0 "#" is set as paused data (1.5 sec.)
1 "#" is set as called number to C.O. line.
CM08
: Initial Data
CHAPTER 3
Page 77
Revision 2.2