[Cm72] Stored Number For System Speed Dialing - NEC NEAX 2000 IVS Command Manual

COMMAND CODE
72
MAT
1. FUNCTION:
This command is used to enter the stored number for the System Speed Dialing feature into the memory
allocated with CM71.
2. PRECAUTION:
(1) When displaying the data, the access code corresponding to the Memory Slot Number is indicated
by the very first
digits of the stored number exceeds 16, the 17th to 26th digits are indicated by the next
(2) Data can only be changed when the access code is displayed. Enter the data in the following order:
new access code, comma, the called number, and
following order: access code on the display, comma, "CCC", and
(3) If "C" is inserted in the called number, when using System Speed Dialing for an Outgoing Tie Line
Call, it can be used as a fixed-length pause (1.5 sec.). To provide a programmable pause with the
stored number, insert "D" instead of "C". The length of the programmable pause is assigned with
CM41 Y = 0, Function 38.
(4) This command is included in the MAT mode menu "E11" (Speed Dialing [COM02]).
3. ASSIGNMENT PROCEDURE:
ST + 72 + DE +
(1) The stored number, for System Speed Dialing, is assigned for each Memory Slot Number, not for the
abbreviated code of each calling party. When assigning stored numbers, the correspondence between
Memory Slot Numbers and abbreviated codes is first to be determined for each kind of calling party,
and then the stored numbers are to be assigned according to the determined correspondence, with each
exclusive memory area assigned in CM71 taken into consideration.
(2) Each stored number should be assigned, including the access code for C.O. line/Tie line, together with
the party's number. The format is as follows:
Stored Number = Access Code + Separator Mark + Called Party's Number
• Access Code:
• Separator Mark:
• Called Party's Number: C.O. network subscriber number or Station number in the distant PBX
[CM72] Stored Number for System Speed Dialing
TITLE:
STORED NUMBER FOR SYSTEM SPEED DIALING
, and the stored number is indicated by the next
DE
MEMORY SLOT
NUMBER
(3 digits)
Access Code (Maximum of 2 digits)
,
to be inserted between the Access Code and the Called Party's
Number
(maximum of 26 digits)
ND-45669 (E)
. For clearing the data, enter the data in the
EXE
EXE
STORED NUMBER
+ DE +
(Max. 28 digits)
CM72
. When the number of
DE
.
DE
.
+ EXE
CHAPTER 3
Page 243
Revision 2.0