NEC NEAX 2000 IVS Command Manual page 237

CM42
COMMAND CODE
42
Note 1: Initial Data in the Data Table represents the value for the data "NONE". In this case, the fol-
lowing conversion is performed in the Deluxe Traveling Class Mark-CCIS.
(1) NEAX2400 to NEAX2000 IVS
NEAX2400
TRK REST. CLASS
0: OG via ATT
1: Unrestricted-1
2: Unrestricted-2
3: Non-Restricted
4: Semi-Restricted
5: Restricted
6: Fully-Restricted
7:
8:
Not Defined
15:
(2) NEAX2000 IVS to NEAX2400
NEAX2000 IVS
TRK REST. CLASS
1: Unrestricted (RCA)
2: Non-Restricted-1 (RCB)
3: Non-Restricted-2 (RCC)
4: Semi-Restricted-1 (RCD)
5: Semi-Restricted-2 (RCE)
6: Restricted-1 (RCF)
7: Restricted-2 (RCG)
8: Fully-Restricted (RCH)
Note 2: This command should be used when changing the initial setting shown above, or when receiving
the NEAX2400 Trunk Restriction Class (9 – 15) as a Deluxe Traveling Class Mark.
CHAPTER 3
Page 202
Revision 2.0
TITLE:
SYSTEM COUNTER DATA/PAD DATA/TRUNK RESTRICTION CLASS
CONVERSION
ND-45669 (E)
NEAX2000 IVS
TRK REST. CLASS
1: Unrestricted (RCA)
1: Unrestricted (RCA)
2: Non-Restricted-1 (RCB)
3: Non-Restricted-2 (RCC)
4: Semi-Restricted-1 (RCD)
5: Semi-Restricted-2 (RCE)
6: Restricted-1 (RCF)
7: Restricted-2 (RCG)
8:
Fully-Restricted (RCH)
8:
NEAX2400
TRK REST. CLASS
1: Unrestricted-1
2: Unrestricted-2
3: Non-Restricted
4: Semi-Restricted
5: Restricted
6: Fully-Restricted
7:
Not Defined
8: