Chapter 3 Description Of Commands; General; Detailed Description Of Commands - NEC NEAX 2000 IVS Command Manual

CHAPTER 3 DESCRIPTION OF COMMANDS

1. GENERAL

This chapter provides a detailed description for each command.

2. DETAILED DESCRIPTION OF COMMANDS

This section describes the methods for programming commands. Information about each command is present-
ed in the following order:
(1) Function:
The function of the command.
(2) Precaution:
Precautions related to assigning data.
(3) Assignment Procedure:
The procedure for assigning data.
(4) Data Table:
A detailed description of the data.
In the description of each command, initial data which is automatically loaded into memory, after system ini-
tialization (using position "B" on SW3 of the MP, followed by a reset) is indicated with "
ter 4 for details on default data when the automatic resident program function (using position "C" on SW3 of
the MP, followed by a reset) is used.
The installer should confirm the meaning of initial data, and change or delete the data, if required. If under the
command code designation there is an
MAT mode of programming instead of the MOC mode or CAT mode.
MAT
abbreviation, then programming can be accomplished by the
ND-45669 (E)
DESCRIPTION OF COMMANDS
". Refer to Chap-
CHAPTER 3
Revision 2.0
Page 61