[Cm00] System Data Memory All Clear - NEC NEAX 2000 IVS Command Manual

CM00
COMMAND CODE
00
1. FUNCTION:
This command confirms that the system data memory (RAM) area can be Written-in /Read-out and also
assigns the Initial Data to the RAM area.
2. PRECAUTION:
(1) This command can only be used in off-line mode.
(2) When this command is executed, "OK" displays with Memory Clear completed (about 30 seconds
later).
(3) If an error exists in memory, "WD ERROR" displays.
(4) This command is not available with a CAT. To clear all system data, set SW3 to "B", and press SW1
on the MP card. In this case, the only functional port is LEN0000, which is assigned as a CAT.
3. ASSIGNMENT PROCEDURE:
ST
+ 00 +
4. DATA TABLE:
DATA
1 System data memory all clear
3 System data clear for new memory area
Note: This data is available when using
CHAPTER 3
Page 62
Revision 2.2
[CM00] System Data Memory All Clear
TITLE:
SYSTEM DATA MEMORY ALL CLEAR
MEMORY AREA
DE
+ DESIGNATION
(1/3)
1ST DATA
MEANING
PN-CP00-C/CP02-C/CP03-C card.
DE
+ + CCC +
DATA
CCC
CCC
ND-45669 (E)
Addendum-002
JANUARY, 1999
EXE
2ND DATA
MEANING
Clear
Clear