NEC NEAX 2000 IVS Command Manual page 380

COMMAND CODE
TITLE:
ID CODE ASSIGNMENT WITH AP
D5
Y
No. MEANING
3 ID Code Entry
A Station Number setting
corresponding to ID code
Note 1: According to the digits to be designated, assign 01FF to the 1st Data 0 and 1 respectively. Digits
18 corresponding to Bits 07 shown below.
ID CODE
DATA (00 FF)
Note 2: When providing a Check Code, the maximum number of ID Code digits available is 8. The Check
Code is displayed on the CAT/MAT in addition to the ID Code entered.
Note 3: The ID Code shall be registered previously at CMD5 Y = 3.
1ST DATA
DATA
X ID Code which is to be
XX dialed in service.
(Exclusive of Check
X......X Code)
Max.
10 digits
Note 2
XX...X ID code
Max. Note 3
10 digits
x
x x x x x x
5
1 2 3 4 6 7
b
0
ND-45669 (E)
MEANING DATA
ABBCC
DDEE
X-XXXX
x
8
b
0/1: Not to be totalled/To be totalled
7
CMD5
2ND DATA
MEANING
Setting of Temporary
Service Class
A: Type of Temporary
Service Class
0: Unrestricted
1: Fully-Restricted
2: Temporary Ser-
vice Class
9: Delete of the ID
Code
B-E:
Temporary
Service Class
(In case of A=2)
B: Trunk Restriction
Class (01-08)
C: Service Feature
Class-A (00-15)
D: Service Feature
Class-B (00-15)
E: Service Feature
Class-C (00-15)
Station Number
CHAPTER 3
Page 337
Revision 2.0