Huawei FusionModule2000 Installation Manual page 200

FusionModule2000 Smart Modular Data Center
Installation Guide (2000 mm High Cabinets, Single-Row
Aisle Containment, 380 V)
Figure 10-17 shows the ports on the SMS modem.
Figure 10-17 Ports on the SMS modem
(1) Connecting to the SIM card
(3) Connecting to the power cable
Procedure
Step 1 Install a SIM card for the modem.
Use a tool such as the small screwdriver to press the yellow key. Put the SIM card on the
ejected tray, and insert the tray into the SMS modem.
Step 2 Attach the antenna (BOM number: 27010824) to the skylight connective plate or the top plate
of the network cabinet outside the contained aisle. Connect the antenna cable to the antenna
port on the modem.
Step 3 Connect the serial cable.
Connect a cable from the modem to an idle serial port on the NetEco server. For the position
of the serial port, see the documents delivered with the NetEco server.
Step 4 Connect the power cable.
Use the power adapter delivered with the modem.


After connecting the power cable, switch on the power supply. The modem indicator should
blink regularly. Table 10-2 describes the relationships between the indicator status and the
modem status.
Issue 04 (2017-06-30)
Do not use the antenna delivered with the modem.
 For the connection method, see the documents delivered with the modem.
 If the serial port on the NetEco server does not match the connector of the serial cable, use the serial
cable adapter delivered with the modem.
Connect one end of the power adapter to the modem. For the connection method, see the
documents delivered with the modem.
Connect the other end of the power adapter to the 220 V power supply through a power
connector (BOM number: 14190143).
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(2) Connecting to the antenna
(4) Serial port
10 Cable Routing
191