Huawei FusionModule2000 Installation Manual page 51

FusionModule2000 Smart Modular Data Center
Installation Guide (2000 mm High Cabinets, Single-Row
Aisle Containment, 380 V)




Procedure
Step 1 Use a forklift truck to transport the PDC to the installation position.
Step 2 Check whether the PDC packing is intact.
Step 3 Cut and remove the binding tape, and remove the packing.
Step 4 Remove the plastic bag and take out the fittings box, sliding plates.
Step 5 Check whether the PDC is intact.
1.
2.
Step 6 After confirming that the PDC is intact, remove the L-shaped brackets that secures the PDC
and the pallet, and insert the two sliding plates under the pallet.
Issue 04 (2017-06-30)
Only trained personnel are allowed to move the PDC. Use a forklift truck to transport the
PDC box secured to a wooden support to the installation position.
To prevent the PDC from falling over, secure the PDC box to the forklift truck using ropes
before moving it.
Move the PDC with caution to avoid bumping or toppling, which may damage the PDC.
After placing the PDC in the installation position, unpack it with care to avoid scratches.
Keep the PDC steady during unpacking.
If the PDC installation environment is in poor condition and the PDC needs to be stored
for a long time after it is unpacked, take measures to prevent dust. It is recommended that
the PDC be wrapped with the original plastic coat.
Check the exterior of the PDC and check whether the PDC is damaged during
transportation. If any damage is found, notify the carrier immediately.
Check that the fittings comply with the packing list. If some fittings are missing or do
not comply with the packing list, record the information and contact your local Huawei
office immediately.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation Preparations
42