4. Master reception ends without all data being received (ST3-0 is 7H)
Note1
N
Note2
Note1: It is not required to read the status as these data are stored in different registers.
As the data will be updated, read the register before the next communication
frame.
Note2: Do not read RDB when RDBE = 1.
The routine for slave receive and multiaddress receive is the same as that of master receive but the status
code is different. Please refer to section 13.5.2 for the status code of slave receive and multiaddress
receive.
MB90580 Series
Begin
Read multiaddress, control
bits and telegraph length bits
number of master receive data byte
STRH/L read
RDBE = 1?
N
Read RDB
Read out master received data
Read out multiaddress, control bits
and master receive byte number
Done by hardware
Y
End
13.5 Operation
Chapter 13: IE Bus
185