Restrictions On Judgment; Error Messages Displayed When You Set A Judgment Formula - Panasonic MICRO-IMAGECHECKER PV310 Use Manual

Hide thumbs Also See for MICRO-IMAGECHECKER PV310:
Table of Contents

Advertisement

7.3.6 Restrictions on Judgment

Contents of Program Formulas
Less than 16 contents and 102 characters can be incorporated into only one formula.
The number of items / characters
that can be incorporated into one
formula
Item
Up to 16
Character
Up to 102
Incorporating a Judgment Result into another Judgment Program
Judgments are output in the ascending order. Therefore, the number of the Judgment formula that you want to
incorporate must be lower than the number of the Judgment formula that you want to incorporate to.
Example:
Correct
JD01=GW01+GW02
JD02=JD01 * CA01
Wrong
JD01=JD02+CA01
JD02=GW01+GW02
In this case, the judgment result obtained from the previous inspection is
substituted for JD02 in Judgment formula JD01.
Calculation Order
Calculations are performed in the following priority order:
Higher
---------------------
(, )
/

7.3.7 Error Messages Displayed When You Set a Judgment Formula

When you set a Judgment formula (hereinafter called a "Judgment formula"), the following messages may be
displayed. In any case, an error is included in the Judgment formula. Recheck and correct it.
Message
Display Timing
E0061: Formula
When saving the
error.
Judgment formula
E0062: Calculation
When copying
error.
from the existing
Judgment formula
E0066: Formula
When saving the
error. Please check
Judgment formula
the checkers used in
the formula.
188
Example of Count
Program
/BW01 + CA01
/BW01 + CA01
Lower
*
#
+
Description
Grammatical error of the Judgment formula
For example,
"JD01=CM01BW01
If the number of the formula to be coped is lower than the number of
the formula to copy.
For example,
The number of copied Judgment formula: JD05 = JD03 + CM01
The number of copied Judgment formula: JD02
(Then, "JD02" becomes equal to "JD03 + CM01"; the judgment result
obtained from the previous inspection was substituted for JD03 in
formula JD02.)
In the case where you attempted to save a formula in which a
checker and the data of Numeric Calculation (CA) and Judgment
(JD) that have not been set.
Result of Count
3 = "/", "BW01+", "CA01"
10

Advertisement

Table of Contents
loading

Table of Contents