Behavior When Ethernet Communication Error - Panasonic MICRO-IMAGECHECKER PV310 Use Manual

9.4.4 Behavior When Ethernet Communication Error

When image output through Ethernet failed, the behavior of PV310 is selectable.
Condition of "Communication error"
This "Communication error" indicates the situation that the device fails to output images correctly because of the
following conditions.
•
Trouble in LAN cable (such as disconnection or loose connection)
•
Image Receiver is not activated.
Behaviors
You can select the following behaviors including taking no action. Both Error signal output and forced outage are
available at the same time.
1 None
2 ERROR Signal Output
3 Forced Outage
ERROR Signal Output
Out puts an error signal through parallel I/O.
Timing of Error Signal Reset (OFF)
Output operation
Outputting error signal singularly
"Forced outage" without image
retransmission
"Forced outage" with image retransmission
Takes no action specially. Ends inspections in the same way as successful
image output.
Outputs an error signal through parallel I/O.
Aborts inspections. When "Output operation" is set to "Synchronous", you can
retransfer the image that is failed to output by keypad operation.
Timing of Reset (OFF)
Depends on "Parallel Reset Condition".
Turns off the error signal when the image is retransmitted.
When retransmission was not completed correctly, outputs an
error-signal again and shows the same message.
237