Table of Contents
Advertisement
10.5.2 Switching the Display Camera Images
You can switch the images to display on the screen by inputting signals from the external device. The display
camera images can be switched by assigning the types of the images to display to IN1-3. The display images are
switched upon the FCT1 (or FCT2) signal input. To do this, it is necessary to assign "Display Camera Image"
function to FCT1 or FCT2 signal (factory default setting of FCT1: Display Camera Image). Refer to Section 9,
"Environment Settings" for settings of FCT1 and FCT2 signals.
Assigning the image to be displayed
Assign the types of images to IN 1 - 3 (3 bit). Refer to
the table shown below.
If you switch the display camera images when
signals IN1 to IN3 are input by a combination
undefined in the table below* of signals and display
images, an error signal is output.
*IN1 – 3 =ON, or IN1=OFF and IN2 and 3 =ON
Timing Chart (when FCT1 is set to "Display Camera Image")
1.
Assign the types of the image that you want to display to IN 1- 3 signals. (Input the data more than
1 ms before FCT1 signal input).
2.
Check READY signal ON and input FCT1 signal.
After READY signal is turned off, the display camera image is changed.
3.
Make sure that the READY signal is off and then turn the FCT1 signal off.
After the product type switch is completed, the READY signal is turned on.
252
Display camera image
Live-C1
Live-C2
Live-C1+C2
Memory-C1
Memory-C2
Memory-C1+C2
IN3
IN2
IN1
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
ON
OFF
ON
Advertisement
Table of Contents
