Output operation
With the use of the Output Operation function, you can specify the time when an inspection image which fulfills
the output conditions is output. Synchronous and Asynchronous are available.
Synchronous
The PV310 outputs an image after inspection is complete, and then turns READY signal ON. Therefore,
READY OFF time becomes longer by the image output time, but the PV310 can output all the images.
(If reset conditions for D1 to D8 = Hold)
Asynchronous
Image output timings are as follows:
•
When READY signal is ON
•
Except image capture during inspection and contour matching
Even if images are output, inspection time (READY signal OFF time) will not extend, but if image output time is
short, images may not be output. Although output condition is set to "Per Start" (or to output all images), some
of the images may not be output.
(If reset conditions for D1 to D8 = Hold)
233