Table of Contents
Advertisement
9.2.2 Protecting the Setting Data Using a Password
A password request function becomes available when switching from the RUN mode to SETUP mode.
A "Password Request" window is displayed when the C key is continuously pressed for more than one second.
Enter the preset password to change to SETUP mode. This function enables you to prevent unwanted changes
of the setting data or to limit a person to change the settings.
Setting the Mode Switch Limit by Password
1.
Select "ENVIRONMENT" from the menu bar.
The ENVIRONMENT menu is displayed.
2.
Select "Initial Settings".
The menu under Initial Settings is displayed.
3.
Select "Password Request".
The subwindow appears. Select "Yes"
(You are required to enter your password when changing to SETUP mode.)
4.
Select "Yes".
The "Password Request" function is activated.
Even if the Password Request function is set to "Yes" when you have not set a password, the "Password
Request" window is not displayed at the time of changing to the SETUP mode.
Canceling the Mode Switch Limit by Password
Select "No" at the step 4 of the setting procedure shown above.
(A password is not required to enter when switching to SETUP mode.)
223
Advertisement
Table of Contents
