Table of Contents
Advertisement
8.6.5 "User-Defined" Execution Mode
Blocks of inspection execution
The data of the checkers, Numeric Calculation formulas and Judgment formulas stored in each product type are
divided into three blocks in numeric order. Each block is called a "block 1", "block 2 or "block 3". In User-Defined
execution mode, you can let the PV310 execute only one block that was selected from three blocks.
Block
Checker
1
No.1 – 32
2
No.33 – 64
3
No.65 – 99
Execution order
Execution of block 1
Execution of statistics
(Only the checkers, Numeric
Calculation formulas or
Judgment formulas of blocks
1 that is set as "objects" are
executed.)
Output of the result
(Block 1 and Statistics data)
To repeat specification execution
If you have set to repeat the specification execution by selecting "ENVIRONMENT" > "Initial Settings" >"Start", the
same block is repeatedly executed. If you want to execute another block, temporarily stop inspection, set to the
desired block and then start inspection again.
•
The block that is executed when the power is turned on: Block 1:
When the power is turned on, block 1 is automatically executed. At this time, input to IN1 or IN2 ports is
not accepted.
•
The block that is restarted after the inspection was suspended: The block that was set at the time of
restarting inspection.
214
Numeric
Judgment
Calculation
CA01 – CA32
JD01 – JD32
CA33 – CA64
JD33 – JD64
CA65 – CA96
JD65 – JD96
Inspection start
Execution of block 2
Execution of statistics
(Only the checkers, Numeric
Calculation formulas or
Judgment formulas of block 2
that are set as "objects" are
executed.)
Output of the result
(Block 2 and Statistics data)
Execution of block 3
Execution of statistics
(Only the checkers, Numeric
Calculation formulas or
Judgment formulas of block 3
that are set as "objects" are
executed.)
Output of the result
(Block 3 and Statistics data)
Advertisement
Table of Contents
