Toshiba GR-200-5 Instruction Manual page 610

Table 4.4-7 Signals generated in control functions
Control Device status generated by the control
function function described on the left column
DPOS
"device status" except "0x40" and "0x80"
BI
signal
†Note: Values are altered when "AND", "OR", or "NOT" is applied as an interlock
operator.
‡Note: Values are altered when "COMP" is applied as an interlock operator.
§Note: Values are altered when the DPOS output is an inverted signal.
Configuration of Interlock formulae
4.4.4
Interlock-check formulae should be stored in the Interlock database, as shown in Figure 4.4-1.
These formulae are configured using GR-TIEMS†, and are uploaded into the ILK interlock
database.
†Note: The configuration of interlock-check formulae is discussed separately. See chapter
Engineering tool: Interlock configurator
0x40(Open)
0x80(Close)
0(off)
- 590 -
"stVal" transposed in the node
0† 0x40‡
1† 0x80‡
0
0
(→p. 706).
6F2T0207 (0.01)
1§
0§
GRE200 (5,6)