ABB i-bus KNX Product Manual page 117

®
ABB i-bus KNX
Commissioning
Dimming time (0 = jump to)
Options: 0...2...65,535 s
This parameter defines the transition between the current and slave brightness, by setting how long
it takes for the slave to dim to slave brightness.
•
0 s: Jump to. The output immediately switches to the slave brightness value.
•
1...65,535 s: During this time, the slave is dimmed from the current brightness value to the
slave brightness value.
Note
When setting dimming times of less than 32 seconds, note that they will be mapped to the
nearest DALI fade time. The conversion is as follows:
Turn on
brightness
in 1 s
0
1
2
3
4
5 and 6
7...9
10...13
14...18
19...26
27...32
> 32...65,535
The fade time is specified as the time required to change the lamp power from the current
brightness value to the required target brightness.
If a lamp is switched off, the preheat and ignition time are excluded from the fade time.
Selection of Can be changed via object "Flexible time for dimming/fade time":
Note – dependency:
Object enabled on "Output functions" page
Fade time in s
acc. to EN 62386-102
jump to
1.0
2.0
2.8
4.0
5.7
8
11.3
16.0
22.6
32.0
Time values with an error tolerance of ±3 s
DG/S x.64.1.1 | 2CDC507164D0201 115