ABB i-bus KNX Product Manual page 75

®
ABB i-bus KNX
Commissioning
Enable Group object
"Slave offset/Status"
Options:
Linked group object:
•
Yes: The group object is required in order to activate or deactivate the offset for the Slave function via
the KNX. The group object affects all groups and ballasts on the output if they are set to Evaluate
Group object "Activate Slave offset" Yes in the Slave parameter window.
•
No: The group object for the Slave offset function on the output is not enabled.
Whether a ballast or group evaluates this group object is defined for each ballast/group in the
corresponding Ballast x or Group x parameter window.
Note
Whether the group or ballast evaluates the telegram received is defined in the corresponding group or
ballast parameter windows. The Activate Slave offset/Status group object can therefore influence any or
all of the ballasts or groups on the output.
Note
The Active offset function can be used e.g. to deactivate the offset between two office lighting strips
when it gets dark. During the day, if the offset is active, the lighting strip nearest the window provides a
brightness value reduced by the offset, thus saving energy.
Yes
No
Selection of Yes option:
Dependent parameters:
Function Slave offset on
KNX recovery and download
Options: Not activated
Activated
This parameter defines the state of the Slave offset function after a KNX recovery or a download.
•
Not activated: The Slave offset function is not activated after a download or after KNX bus
voltage recovery. The Activate slave offset group object receives a value of 0.
•
Activated: The Slave offset function is activated after a download or after KNX bus voltage
recovery. In other words, an offset is applied to the slave. The Activate slave offset or Activate
Slave offset/Status group object receives a value of 1.
Activate Slave offset/Status
DG/S x.64.1.1 | 2CDC507164D0201 73