ABB i-bus KNX Product Manual page 66

®
ABB i-bus KNX
Commissioning
Enable Group object
"No of ballast faults"
Options:
Linked group object:
•
Yes: The group object is enabled. This group object indicates the number of faulty DALI devices on
the output. In this case a fault means lamp or a ballast fault.
•
No: The group object is not enabled.
64 2CDC507164D0201 | DG/S x.64.1.1
Yes
No
Selection of Yes option:
Dependent parameters:
Send object value
Options: On change
On request
After a change or on request
•
On change: The status is sent when a change occurs.
•
On request: The status is sent when a request occurs.
•
After a change or on request: The status is sent when either a change or request occurs.
Number of ballast faults