ABB i-bus KNX Product Manual page 211

®
ABB i-bus KNX
Commissioning
No.
928, 931... Trigger em lighting test (DGN/S)
This group object is enabled if an Emergency light x is enabled in X lighting converter/Emergency light template parameter
window, p. 155. The object can adopt one of 3 data formats. The data format is defined in the A lighting converter, Emergency
light x parameter window by setting the Enable Group Objects "Trigger em lighting test" parameter to Yes, DGN/S 1.16.1
format.
This group object triggers an emergency lighting test for emergency light x. It does not send the status or the emergency
lighting test result from the gateway on the KNX.
The following numbering applies to the list below:
7
2
The bit number is identical to the exponent of the bit, e.g. number 2 corresponds to 2
Bit 0...2
Bit 3...7
If a new test is requested on the group object before the ongoing test has ended, this is immediately interrupted and the new
test is requested. This is also the case when the ongoing test is requested again. Only one test can be undertaken on the
emergency lighting converter at any time.
1)
See Application Notes 166/14v03 para. 2.8.2.8 LEGACY CTT
Function
6 5 4 3 2
2 2 2 2 2 2
= 000, stops the test currently running
= 001, function test is requested
= 010, partial duration test is requested
= 011, duration test is requested
= 100, battery is queried
= 101, 110 and 111 without function or not taken into account in the request evaluation
= 0, without function or not taken into account in the request evaluation.
Note
The result of the emergency lighting test for each converter can be sent on the KNX with the addressed group object
Em lighting test result (no. 42) or the Em lighting test status group object (no. 929ff).
Group object name
Output A - Emergency light x
1 0
2
Data type Flags
1 byte C, W
1)
Non DPT
2
.
DG/S x.64.1.1 | 2CDC507164D0201 209