®
ABB i-bus
KNX
Commissioning
Enable Group objects for additional
fault message displays
"Ballast number fault"
"Switch up next ballast fault"
Options:
Linked group object:
This parameter enables two group objects. The first indicates the number of the faulty ballast. If there are
several faults, the address of the next device with a fault can be displayed via the Switch up next ballast
fault group object. Here, a fault means a lamp or ballast fault.
•
Yes: The expanded ballast fault message display is enabled.
•
No: The additional group objects for number-dependent device fault display are not enabled.
Enable Group object
"No of group faults"
Options:
Linked group object:
•
Yes: The group object is enabled. This group object indicates the number of faulty groups on the
output. Here, a fault means a lamp or ballast fault.
•
No: The group object is not enabled.
Yes
No
Yes
No
Selection of Yes option:
Dependent parameters:
Send object value
Options:
On change
On request
After a change or on request
•
On change: The status is sent when a change occurs.
•
On request: The status is sent when a request occurs.
•
After a change or on request: The status is sent when either a change or request occurs.
Ballast number fault
Switch up next ballast fault
Number of group faults
DG/S x.64.1.1 | 2CDC507164D0201 65