®
ABB i-bus
KNX
Commissioning
Enable Group object
"Fault addressed"
Options:
Linked group object:
Depending on parametrization, this group object sends the status of a group or ballast fault in the 2-byte
coded group object Fault addressed. However, the parameters can also be queried.
•
Yes: The group object is enabled. As soon as there is a ballast, lamp or other fault on a DALI device
on the output, this is indicated by a value of 1 in the corresponding bit.
•
No: The group object is not enabled.
62 2CDC507164D0201 | DG/S x.64.1.1
Selection of Yes option:
Dependent parameters:
Send object value
Options:
On change
On request
After a change or on request
•
On change: The status is sent when a change occurs.
•
On request: The status is sent when a request occurs.
•
After a change or on request: The status is sent when either a change or request occurs.
Yes
No
Selection of Yes option:
Dependent parameters:
Send object value
Options:
On change
On request
After a change or on request
•
On change: The status is sent when a change occurs.
•
On request: The status is sent when a request occurs.
•
After a change or on request: The status is sent when either a change or request occurs.
Fault addressed