ABB i-bus KNX Product Manual page 20

®
ABB i-bus KNX
Device technology
Manual operation
The gateways have a manual operation option to switch DALI lamps on and off at the outputs. However
this excludes DALI single battery lamps, which cannot be manually operated.
Supplied state
The device is supplied with the physical address 15.15.255. The application program is preloaded.
It is therefore only necessary to load group addresses and parameters during commissioning.
However, the complete application program can be reloaded if required. Longer downtime may result if the
application program is changed or after a discharge.
Allocation of the physical address
The physical address is assigned and programmed in ETS.
The device shoulder features a push button for allocation of the physical device address.
The red LED
the physical address or the button is pressed again.
Download response
Because of the complexity of the device, the progress bar for download may take up to 90 seconds to
appear depending on the PC used.
Cleaning
If devices become dirty, they can be cleaned using a dry cloth or a cloth dampened with a soapy solution.
Corrosive agents or solutions must never be used.
Maintenance
The device is maintenance-free. In the event of damage, e.g. during transport and/or storage, do not carry
out any repairs.
18 2CDC507164D0201 | DG/S x.64.1.1
lights up after the button has been pushed. It switches off as soon as ETS has assigned