ABB i-bus KNX Product Manual page 118

®
ABB i-bus KNX
Commissioning
Offset between slave and master
Options:
A brightness offset can be factored in between the master and slave.
•
Yes: An offset from the specified master brightness is taken into account for the slave. The Activate
offset group object is also enabled. This allows the offset to be switched off e.g. in darkness to restore
uniform lighting levels in the room.
•
No: No brightness value offset is taken into account for the slave; it is controlled by the master
brightness value.
116 2CDC507164D0201 | DG/S x.64.1.1
Yes
No
Selection of Yes option:
Dependent parameters:
Offset between slave and master
(% difference from master value)
Options: -99%
-98%
...
0%
...
+98%
+99%
This parameter defines the offset that controls the slave relative to the master. The setting is
expressed as a percentage difference from the master brightness value.