Dali Output X Parameter Window; Dali Configuration Parameter Window - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
3.2.2

DALI output X parameter window

General parameter settings for output X are made in this window.
3.2.2.1 X DALI configuration parameter window
The main parameter settings defining the entire DALI output are made in this window. Various control
options for the DALI devices are enabled from this page.
Enable automatic DALI addressing
Options:
This parameter switches off the DG/S automatic DALI addressing process.
•
Yes: If the DG/S locates a DALI device without a DALI address, the DG/S automatically allocates it the
first free DALI address.
Advantage
DALI addressing without gaps makes it possible to replace a defective DALI device without additional
addressing or commissioning. All that is required is to connect a new DALI device without a DALI
address.
The DG/S addresses the new device with the first free DALI address of the removed failed device, and
transfers its properties to the new device. If this DALI device does not yet have a group address (it is
new from the factory), it will also receive the group assignment. If another group assignment exists in
the DALI device, a conflict will be indicated in the ABB i-bus
ABB i-bus
If the DG/S detects several DALI devices with the same DALI address, it deletes these addresses and
automatically assigns them the first free DALI addresses in the address range.
Yes
No
®
Tool by applying the DG/S or ballast information.
®
Tool. This can be remedied with the
DG/S x.64.1.1 | 2CDC507164D0201 35