ABB i-bus KNX Product Manual page 204

®
ABB i-bus KNX
Commissioning
No.
52, 63...
228, 239...
This group object receives a brightness value for the corresponding group x or ballast x. Any burn-in time currently running
has a higher priority, so under certain circumstances individual devices can only adopt a brightness of 100% or OFF.
Dimming time to reach brightness value is defined in X template group x/ballast x parameter window, p. 77.
Brightness values above or below the predefined maximum brightness/minimal dimming values (dimming thresholds) are not
set.
Telegram value:
53, 64...
229, 240...
This group object is enabled if the Enable Group object "Status brightness value" parameter is set to Yes in the X template
group x/ballast x parameter window, p. 77.
Telegram value:
This group object signals the status of the current brightness value of group x or ballast x.
The brightness value displayed can be limited by the minimum/maximum dimming thresholds.
You can define:
•
•
202 2CDC507164D0201 | DG/S x.64.1.1
Function
Brightness value
Dependent on parameter
0 = OFF
...
255 = 100%
Status brightness value
Dependent on parameter
0 = OFF
...
255 = 100%
whether the value of the group object is updated during a dimming process or whether the status is only sent once the
final value has been reached.
whether the status is sent On change and/or On request.
Group object name
Output A - Group x
Output A - Ballast x
None
Output A - Group x
Output A - Ballast x
Enable Group object "Status brightness value"
Data type Flags
1 byte C, W
DPT 5.001
1 byte C, R, T
DPT 5.001