NEC 78K0 Series User Manual page 527

Table 22-2. Hardware Statuses After Reset Acknowledgment (2/3)
8-bit timer/event Timer counters 50, 51 (TM50, TM51)
counters 50, 51
Compare registers 50, 51 (CR50, CR51)
Timer clock selection registers 50, 51 (TCL50, TCL51)
Mode control registers 50, 51 (TMC50, TMC51)
8-bit timers H0, H1 Compare registers 00, 10, 01, 11 (CMP00, CMP10, CMP01, CMP11)
Mode registers (TMHMD0, TMHMD1)
Carrier control register 1 (TMCYC1)
Watch timer Operation mode register (WTM)
Clock output/buzzer Clock output selection register (CKS)
output controller
Watchdog timer
Enable register (WDTE)
A/D converter 10-bit A/D conversion result register (ADCR)
8-bit A/D conversion result register (ADCRH)
Mode register (ADM)
Analog input channel specification register (ADS)
A/D port configuration register (ADPC)
Serial interface Receive buffer register 0 (RXB0)
UART0
Transmit shift register 0 (TXS0)
Asynchronous serial interface operation mode register 0 (ASIM0)
Asynchronous serial interface reception error status register 0 (ASIS0)
Baud rate generator control register 0 (BRGC0)
Serial interface Receive buffer register 6 (RXB6)
UART6
Transmit buffer register 6 (TXB6)
Asynchronous serial interface operation mode register 6 (ASIM6)
Asynchronous serial interface reception error status register 6 (ASIS6)
Asynchronous serial interface transmission status register 6 (ASIF6)
Clock selection register 6 (CKSR6)
Baud rate generator control register 6 (BRGC6)
Asynchronous serial interface control register 6 (ASICL6)
Input switch control register (ISC)
Serial interfaces Transmit buffer registers 10, 11 (SOTB10, SOTB11)
Note 4
CSI10, CSI1
Serial I/O shift registers 10, 11 (SIO10, SIO11)
Serial operation mode registers 10, 11 (CSIM10, CSIM11)
Serial clock selection registers 10, 11 (CSIC10, CSIC11)
Notes 1. During reset signal generation or oscillation stabilization time wait, only the PC contents among the
hardware statuses become undefined. All other hardware statuses remain unchanged after reset.
2. 8-bit timer H1 only.
3. The reset value of WDTE is determined by the option byte setting.
4. Serial interface CSI11 is available only in the
78F0537D.
CHAPTER 22 RESET FUNCTION
Hardware
Note 2
µ
PD78F0534, 78F0535, 78F0536, 78F0537, and
Preliminary User's Manual U17260EJ3V1UD
Status After Reset
Note 1
Acknowledgment
00H
00H
00H
00H
00H
00H
00H
00H
00H
Note 3
1AH/9AH
0000H
00H
00H
00H
00H
FFH
FFH
01H
00H
1FH
FFH
FFH
01H
00H
00H
00H
FFH
16H
00H
00H
00H
00H
00H
527