Panasonic MICRO-IMAGECHECKER AX40 User Manual page 127

6.12.3 What To Do If You Faced a Trouble
You want to delete only the preset horizontal/vertical edges.
Highlight the tab of the edge you want to delete and press the B key. Select "Delete" from the menu to
delete only the areas.
Whenever you delete only the preset horizontal or vertical edges, the judgement
results are NG.
The following causes may be occurred.
• The object cannot be detected
Recheck and reconsider the area size and the detection conditions (including
Target, Filter, Width, and Priority).
• No base position is registered.
The error code "E0049" may be displayed.
Since any base position is not registered, AX40 cannot work properly. Note that if you do the followings
after registering it, you need to register the base position again.
- Changing area position, size and shape
- Adding horizontal or vertical edge
- Changing priority
• Position Adjustment that refers to adjustment amount cannot detect the object.
If Position Adjustment is set to the numbers except "0", the adjustment amount of Position Adjustment or
Rotation Adjustment that is registered to the number is referred. If the Position Adjustment or Rotation
Adjustment checker cannot detect the object, the adjustment amount cannot be referred. Therefore, AX40
does not function properly and outputs "NG" result.
119