Panasonic MICRO-IMAGECHECKER AX40 User Manual page 239

Gray Edge - Changing Edge Threshold (%G)
This is a command to change the edge threshold of the specified object checker. The currently selected
binary level can be changed on the AX40.
Gray Edge - Changing Edge Threshold: Gray Edge Checker
Sending Command from External Device (Command Digit: "Valid")
Communication Command / Description
direction
Sending
Command from
External Device
?? : 01 - 99 (To specify gray edge checker No.)
nnn : 001 - 255 (To specify edge threshold)
Response: At
normal operation
(at the end of
?? : 01 - 99 (Checker No.)
setting)
nnn : 001 - 255 (Edge threshold)
Response: Error 1
Cause
•
Response: Error 2
ERROR signal is
output from the
Cause
parallel output port.
•
•
% G ? ? , n n
% G ? ? , n n
% U CR
Command in the unspecified form or not provided was received.
Examples:
C
- %G1,80 (any other checker number than 01 - 99 was specified.)
R
C
- %B01,80 (not provided command)
R
% Z CR
The target checker is not assigned to the number of the type specified by a sending
command.
The edge threshold specified by a sending command is not between 1 and 255.
n CR
n CR
231