Starting Inspection - Panasonic MICRO-IMAGECHECKER AX40 User Manual

5.8 Starting Inspection

Execute inspection according to your settings.
1. Switch to RUN mode.
Keep pressing the C key until the menu bar disappears.
2. Press the A key.
Inspection is started, and the total judgement results or output status of the signal from terminal board are
displayed in the status display area which is located at the left side of the monitor screen. At this time, even
if START signal is input or serial commands for inspection are sent by using the external device, the total
judgement results or the output status of the signal is displayed the status display area.
61