Toro 30284 Service Manual page 121

LINKAGE
4. Secure the drive lever handle with a nut (Fig. 0342).
4
5. Assemble the thumb latch, bolt, and washers as
shown.
Note: The Belleville washers should be assembled
onto the bolt in an alternating fashion (i.e.
crown out, crown in, crown out) (Fig. 0343).
A
A. Bolt
B. Belleville washer (3)
4-14
Fig 0342
B B B
C
Fig 0343
C. Thumb latch
D. Flat washer
6. Slide the bolt of the thumb latch assembly into the
hole on the handle bar (Fig. 0344).
PICT-0699
7. Install a nut onto the bolt securing the thumb latch
assembly to the handle bar (Fig. 0345).
Note: When tightening the nut, do not over-tighten.
The thumb latch must move freely, without
rattling.
D
PICT-0697a
Fig 0344
Fig 0345
Floating Deck Mid-Size Service Manual
PICT-0696
PICT-0694