Adjusting The Left Side Linkage (Pistol Grip) - Toro 30284 Service Manual

LINKAGE

Adjusting the Left Side Linkage (Pistol Grip)

1. Disengage the PTO and set the parking brake.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Support the rear of the machine on jack stands so
the drive wheels are off of the ground.
4. Disengage the parking brake.
5 Start the engine and move the throttle to the full
throttle position.
6. Press and hold the OPC levers down.
Note: The OPC levers must be held down whenever
the speed control lever is out of the neutral
4
position or the engine will kill.
7. Place the left drive lever in the full forward position.
8. Place the speed control lever in the neutral position.
Electrical system will not perform proper safety
shut off with Operator Presence Control (OPC)
levers fastened in place.
• Make sure Operator Presence Control (OPC)
levers are working when adjustment is
completed.
• Never operate this unit with Operator Presence
Control (OPC) levers fastened in place.
4-124
!
!
9. Loosen the front adjusting nut on left hydro control
linkage as shown in (Fig. 0768).
A
D
Fig 0768
A. Hydro control linkage
B. Front adjusting nut
10. Turn the rear adjusting nut counterclockwise until
wheel rotates forward (Fig. 0768).
11. Turn the rear adjusting nut clockwise 1/4 of a turn.
Then move the speed control lever forward and back
to neutral. Repeat this until left wheel stops rotating
forward (Fig. 0768).
Floating Deck Mid-Size Service Manual
C
B
fi g. 48 G001519
C. Rear adjusting nut
D. Control arm