Toro 30284 Service Manual page 414

5. Move the bail to the operation position and tempor-
arily tie it in place (Fig. 1409).
Fig 1409
6. Attach the test lead to the brown wire and pull the
clutch switch, the voltage should not change (Fig.
1410).
If the voltage does change: Trace the problem back
through the wire harness and switches.
If the voltage does NOT change: Check the PTO clutch
and module ground connections, step 7 and 8.
Fig 1410
Floating Deck Mid-Size Service Manual
7. Set the Volt/Ohm meter to the OHMs setting. Con-
nect a test lead to the green wire at the module
connector. Connect the other test lead to the engine
block (Fig. 1411). The reading should be 2.8 OHMs.
A higher reading indicates a poor connection on the
green wire, the clutch or ground. Clean and secure all
connection points.
A lower reading indicates a problem with the clutch coil.
IMG_8066a
IMG_8051a
ELECTRICAL
Fig 1411 IMG_8056a
9
9-7