Table of Contents
Advertisement
Note: Do not access undefined locations in either area The operation of an access to an
undefined location is undefined. Also, memory-mapped registers must be accessed using a
fixed data size. The operation of an access using an invalid data size is undefined.
2.4
Data Format in Registers
Register operands are always longwords (32 bits). When a memory operand is only a byte (8 bits)
or a word (16 bits), it is sign-extended into a longword when loaded into a register.
2.5
Data Formats in Memory
Memory data formats are classified into bytes, words, and longwords. Memory can be accessed in
8-bit byte, 16-bit word, or 32-bit longword form. A memory operand less than 32 bits in length is
sign-extended before being loaded into a register.
A word operand must be accessed starting from a word boundary (even address of a 2-byte unit:
address 2n), and a longword operand starting from a longword boundary (even address of a 4-byte
unit: address 4n). An address error will result if this rule is not observed. A byte operand can be
accessed from any address.
Big endian or little endian byte order can be selected for the data format. The endian should be set
with the MD5 external pin in a power-on reset. Big endian is selected when the MD5 pin is low,
and little endian when high. The endian cannot be changed dynamically. Bit positions are
numbered left to right from most-significant to least-significant. Thus, in a 32-bit longword, the
leftmost bit, bit 31, is the most significant bit and the rightmost bit, bit 0, is the least significant
bit.
The data format in memory is shown in figure 2.5.
31
Longword
0
Rev. 4.0, 04/00, page 21 of 850
Advertisement
Table of Contents
