Table of Contents
Advertisement
= 111) when the required amount of data has been transferred. This will terminate
DMA transfer on channel 0.
In this case, the TE bit in DMA channel control register 0 is not set, but transfer cannot
be restarted.
6. When port functions are used (BCR2.PORTEN = 1) and DDT mode is selected, input
the DTR format for D[63:52] and D[31:0]. In this case, if ID[1:0] = 00, input MD[1:0]
= 00.
14.5.3
Transfer Request Acceptance on Each Channel
On channel 0, a DMA data transfer request can be made by means of the DTR format. No further
transfer requests are accepted between DTR format acceptance and the end of the data transfer.
On channels 1 to 3, output a transfer request from an external device by means of the DTR format
(ID = 01, 10, or 11) after making DMAC control register settings in the same way as in normal
DMA mode. Each of channels 1 to 3 has a request queue that can accept up to four transfer
requests. When a request queue is full, the fifth and subsequent transfer requests will be ignored,
and so transfer requests must not be output.
Rev. 4.0, 04/00, page 479 of 850
Advertisement
Table of Contents
