Trunk Access Code - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Level:
IN
Description
Use
access code can be set from 1~8 digits which is defined to type 3 and 4 in Program
11-01. This is the code extension users dial to access Automatic Route Selection. The
Individual Trunk Access Code is used when Trunk Group Routing is desired for an
outgoing line.
Input Data
Item
Programming Manual
Program 11 : System Numbering
Program 11-09: Trunk Access Code
The digit 9 is defined in Program 11-01 as Dial Type() with the Number of Digits
Required set to (). If you change the trunk access code in Program 11-09, you
must make the corresponding changes in Program 11-01.
Trunk Access
No. Code
01
Dial
(Up to four digits)

11-09 : Trunk Access Code

to assign the trunk access code. The trunk
Caution!
Description
Use this program to
assign the trunk access
code (normally 9). This is
the code extension users
dial to access Automatic
Route Selection.
Issue 10.1
Default Related Program
9 (OT)
11-01 : System

Numbering
0 (AU)
14-01 ~ 07: Basic

Trunk Data Setup
14-05 : Trunk Group

14-06: Trunk Group

Routing
21-02: Trunk Group

Routing for
Extensions
2 - 103