Program 34 : Tie Line Setup; 34-01: E&M Tie Line Basic Setup - NEC Univerge SV8100 Programming Manual

Level:
IN
Description
Use Program 34-01: E&M Tie Line Basic Setup to define the basic settings
for each E&M Tie line.
Input Data
Item
No.
01
02
03
04
Programming Manual

Program 34 : Tie Line Setup

34-01: E&M Tie Line Basic Setup
Trunk Port Number
Item Input Data
0 = 2 nd Dial Tone
DID/E&M
Start
1 = Wink
Signaling
2 = Immediate
3 = Delay
0 = DP
Receive Dial
Type
1 = DTMF
for E&M Tie
Line
0 = Specify
E&M Dial-In
Mode
Extension
Number
(Intercom)
1 = Use
Conversion
Table (NTT)
0 = Disable (No)
E&M Line Dial
Tone
1 = Enable (Yes)
001~200
Default Description
0 (OT) Set the start signaling
2 (AU)
mode for DID and Tie
trunks. DID and Tie
trunks can use either
immediate start or
wink start signaling.
1
0 Determine if the
incoming Tie Line call
should be directed as
an intercom call or if it
should follow the DID
Translation Table in
Program 22-11.
1 Enter 1 if the Tie Line
should send dial tone
to the calling system
after the call is set up.
Enter 0 if the Tie Line
should not send dial
tone.
Program
34
Related
PRG
22-02
10-09
22-11
2 - 453