81-11: Tie Line Initial Setup - NEC Univerge SV8100 Programming Manual

UNIVERGE SV8100
Program 81 : Basic Hardware Setup for Trunk
Level:
IN
Description
Use Program 81-11: Tie Line Initial Setup to define the various initial data for DID/
TLI/DTI packages.
Input Data
Item
No.
01
02
03
04
Programming Manual
Trunk port Number
Item
DP Interdigit Time Selection
The DP Interdigit Time is the minimum
pause time between dial pulses. Select
either Pattern A or pattern B.
Prepause Time Selection
Specify the loop open time for a hookflash
signal sent to the Tie Line when the Recall
key on a multiline terminal is pressed. A
Single Line Telephone (SLT) generates a
hookflash to the Tie Line when a SLT
hookflash is assigned.
Tie Line Answer Detect Time Selection
Specify the time before a UNIVERGE
SV8100 system answer (Off-Hook) is
recognized as an answer.
Tie Line Release Detect Time Selection
Specify the circuit disconnect detected on
the Tie Line on the distant system side is
recognized as Tie Line.

81-11: Tie Line Initial Setup

1~ 200
Input Data
0 = Pattern A
(Pattern A: 10pps – 650ms,
20pps – 500ms)
1 = Pattern B
(Pattern B: 10pps – 800ms,
20pps – 800ms)
1~4
(1~4 = 0.5~2.0 seconds)
(5~15 = 3.0~13 seconds)
(0 = No Setting)
0~15
(130ms~1950ms)
(0 = No Setting)
0~15
(130ms~1950ms)
(0 = No Setting)
Issue 10.1
Default
1
0
(No Setting)
4
(520ms)
4
(520ms)
2 - 719