NEC Univerge SV8100 Programming Manual page 584

Issue 10.1
Input Data (Continued)
2 - 548
Item
Item
No.
05
Message Wait
Enable/disable the system ability to
process the Voice Mail Message Wait
( ) commands. You should normally
#
enable this option. If enabled, be sure
that the programmed Message
Notification strings don't contain the
code for trunk access.
06
Record Alert Tone Interval Time
This time sets the interval between
Voice Mail Conversation Record alerts
07
Centralized Voice Mail Pilot Number
This number is the same as the
extension number or pilot number.
08
Centralized Voice Mail Department
Group Number
Assigns which Extension (Department)
Group Number is used as the
Centralized Voice Mail group.
09
Centralized Voice Mail Master Name
Assigns the Centralized Voice Mail
Master Name.
10
New NSL Protocol support
11
Prefix for Call Screening
12
Prefix for Park and Page
13
Prefix for Message Wait
14
CCIS Centralized Voice Mail Number
Assign the pilot number to Centralized
Voice Mail over CCIS Link. This is
assigned only in the remote switches.
15
Analog Voice Mail Protocol Selection
Assigns whether fixed codes are used
or the codes used in PRG 45-04 are
used for analog voice mail protocol.
16
Voice Mail Fax Digit Add Assignment
Assign up to four digits in front of the
station number sent to the SLT port
when a call is forwarded.
UNIVERGE SV8100
Input Data Default
0 = Off 1
1 = On
0~64800 (sec) 30 (OT)
0 (AU)
Dial (up to eight No
Setting
digits)
0~64 0
Up to 12 "C.V.M."
characters
0
0 = Off
1 = On
Dial (One digit) 1
Dial (One digit)

Dial (One digit)
#
Dial (up to eight No
Setting
digits)
0: Fixed 0
1: Program
Up to four digits None
Program 45 : Voice Mail Integration
Related
PRG
45-01-13
45-01-03
45-01-04
45-01-05
45-04
11-11-
50/51
15-03-16