NEC Univerge SV8100 Programming Manual page 857

UNIVERGE SV8100
Item
Programming Manual
No.
19
Idle Noise Level
Set the noise level which is generated when
silent.
Not used by IPLB.
20
Echo Canceller Mode
Determine whether or not to use Echo
canceller.
Not used for IPLB. Echo canceller setup is
84-31 by IPLB.
21
Signal Limiter
Set the Signal Limiter Mode.
Not used by IPLB.
22
Echo Canceller NLP Mode
Non-linear processing mode.
Enable this option to decrease the low level
echo. When NLP is enabled, the voice with
low level is replaced with NLP noise. As a
result, a low echo of the level is usually
removed compared with the conversation
level.
Not used by IPLB. Echo canceller setup is
84-31 for IPLB.
24
Echo Canceller NLP Noise Setting
Becomes invalid item if 84-24-22 is set to
Disabled.
Set the noise level adjusting method added
with NLP.
When "0" is set, the level is self-adjusted -
when "1" is set, Program 84-24-22 is used.
Not used by IPLB. Echo canceller setup is
84-31 for IPLB.
26
TX (Transmit) Gain
Define the setting to amplify and to attenuate
the size of the transmission voice. The gain
given when the voice packet is sent from the
VOIPDB is set.
Not used by IPLB. Echo canceller setup is
84-31 for IPLB.
Item Input Data
5000-7000
(-5000 ~ -7000dbm)
5000 = -5000dbm
:
7000 = -7000dbm
0 = Disable
1 = Enable
1 = Mode0
2 = Mode1
3 = Mode2
4 = Mode3
5 = Mode4
6 = Mode5
0 = 2 wire & 4 wire
1 = 2 wire only
0 = adaptive
1 = fixed
0-40 (-20 ~ +20)
0 = -20 dbm
1 = -19 dbm
:
20 = 0 dbm
:
39 = 19 dbm
40 = 20 dbm
Issue 10.1
Default
7000
1
6
1
0
20 (0dbm)
2 - 821