NEC Univerge SV8100 Programming Manual page 30

Issue 10.1
Use this keypad digit . . .
U
S 7
SING
ECTION
Each UNIVERGE SV8100 display telephone provides interactive Softkeys for intuitive
feature access. The options for these keys will automatically change depending on
where you are in the system programming. Simply press the Softkey located below
the option you wish and the display will change accordingly.
Pressing the
1 - 6
Table 1-2 Keys for Entering Names
When you want to. . .
Enter characters:


# = Accepts an entry (only required if two letters on the same
#
key are needed – ex: TOM). Pressing # again = Space. (In
system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)
Clear the character entry one character at a time.
Recall
Clear all the entries from the point of the flashing cursor and to
Hold
the right.
S F
OFTKEYS OR
_
Program Mode
Base Service OP1
               
VOLUME  or VOLUME
_
Program Mode
CCIS Hard Mtnance
               
+ , - . / : ;
P
ROGRAMMING
OP2
 will scroll between the menus.
UNIVERGE SV8100

B E
< = > ?
S 
¢ £
Introduction