NEC Univerge SV8100 Programming Manual page 863

UNIVERGE SV8100
Input Data
Item
Programming Manual
No.
38
Number of G.726 Audio Frames
39
G.726 Voice Activity Detection Mode
40
G.726 Jitter Buffer (min)
41
G.726 Jitter Buffer (Average)
42
G.726 Jitter Buffer (max)
43
iLBC Audio Frame
Maximum number of iLBC Audio Frames.
iLBC assumes the frame of 10ms is a unit.
44
iLBC Silence Compression Mode
Select whether to compress silence with
iLBC. When there is silence, the RTP packet
is not sent.
Not used by IPLB.
45
iLBC Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of
iLBC is set. Jitter is the variation in the time
between packets arriving and the buffer
allows this variation to be absorbed.
46
iLBC Jitter Buffer - Standard
Set the average iLBC Jitter Buffer.
47
iLBC Jitter Buffer - Maximum
Set the maximum iLBC Jitter Buffer.
48
ILBC Payload Number
The payload number of iLBC is set. However,
the same number as Item 31 cannot be set.
49
RTP Filter
To avoid incorrect voice pass connection, this
Program checks the sending side address
from received RTP packet at VoIPDB.
50
DTMF Level Mode
Used only by IPLB.
Item Input Data
1~4
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
0 = Disabled
1 = Enabled
0~255ms (Note 2)
0~255ms (Note 2)
0~255ms (Note 2)
2 = 20 ms
3 = 30 ms
4 = 40 ms
0 = Disable
1 = Enable
0~255ms (Note 2)
0~255ms (Note 2)
0~255ms (Note 2)
96-127
0 = Disable
1 = Enable
0 = VoIPU default value
1 = Main soft value
Issue 10.1
Default
3
0
30
60
120
3
0
30
60
120
98
1
0
2 - 827