Operations For Display - Mitsubishi Electric GOT2000 Series User Manual

7.3

Operations for Display

This section explains how to display the Q motion monitor screen after the GOT is turned on.
Step 1.
Turn on the power to the GOT.
Step 2.
Display the Q motion monitor screen by one of the following methods.
• Starting from the special function switch (Q motion monitor) set in the project data
For information on how to set special function switches, refer to the following.
➠
GT Designer3 (GOT2000) Screen Design Manual
• Starting from the utility
In the utility, touch [Monitor] → [Motion monitor] from the main menu.
For information on to display the utility, refer to the following.
➠ GOT2000 Series User's Manual (Utility)
Step 3.
Set the channel number.
Set the channel number of the controller monitoring the Q motion.
After turning on the GOT, the communication setting window is displayed at the first startup of the Q motion
monitor only.
For displaying the communication setting window at the second or later startup, touch the [Ch: ] key on the
Q motion monitor screen.
➠
7.4 Operation Procedures
Step 4.
Start the Q motion monitor.
The system configuration screen appears after the channel No. is selected.
Touch a motion controller CPU to monitor.
Touching the [Parameter Set.] key displays the parameter setting screen.
Touching the [Motion Monitor] key displays the monitor menu.
Communication setting window
7.3 Operations for Display
7
7 - 5