Mitsubishi Electric GOT2000 Series User Manual page 540

17.2.3 Precautions
■1. Before using the CNC monitor
Read the manual of the connected CNC carefully and make sure you understand the contents before using the CNC
monitor.
■2. Available controllers
The CNC monitor can be used with CNC C70 and MELDAS C6/C64.
(1) CNC C70
Use a CNC C70 with the system software version BND-1006W000-A0 or later.
(2) MELDAS C6/64
Use a MELDAS C6/C64 with the system software version BND-377W010-D0 or later.
17.3 Operations for Display
This section explains how to display the CNC monitor screen after the GOT is turned on.
Step 1.
Turn on the power to the GOT.
Step 2.
Display the CNC monitor screen.
Use either of the following display methods.
• Starting from the special function switch (CNC monitor) set in the project
For how to set special function switches, refer to the following.
➠
• Starting from the utility
After the utility is displayed, touch [Monitor] → [CNC monitor] from the Main Menu.
For how to display the utility, refer to the following.
➠
Step 3.
Set the channel number.
Set the channel number of the controller to be monitored with the CNC monitor.
After the GOT is powered on, the communication setting window is displayed only at the first startup of the
CNC monitor.
For displaying the communication setting window at the second or later startup, touch the [ch:] key on the
CNC monitor screen.
➠
17 - 4
17.3 Operations for Display
GT Designer3 (GOT2000) Screen Design Manual
GOT2000 Series User's Manual (Utility)
17.4 Operation Procedures
Communication setting window