Common Operation; Information And Key Functions Displayed On The Screen - Mitsubishi Electric GOT2000 Series User Manual

13.4 Common Operation

This section describes the information and key functions displayed on the FX ladder monitor screen.
13.4.1

Information and key functions displayed on the screen

■1. When the FX ladder monitor is executed
(1) Display monitor
1)
2)
3)
The information shown in the table below is displayed.
No.
Sequence program is displayed.
A maximum of 11 contact points is displayed in one line of a ladder; for 12 contact points or more, move to the next line.
When a comment display is specified, a comment is also displayed; expanded comments are given priority.
1)
For the method of displaying comments, see the following:
➠
13.5.3 Switching comment/no-comment display
A maximum of eight devices is displayed for the word device current value, timer and counter current value (upper row),
and set value (lower row). When the set value is an indirect specification, the value of the indirectly specified device is
displayed.
2)
To switch between decimal and hexadecimal for the displayed value, see the following:
➠
13.5.2 Display switching of decimal numbers/hexadecimal numbers
Display the keys used with the operation on the FX ladder monitor screen shown in (b)
3)
(Touch input).
4) The display step number (left) and the remaining step number (right) are displayed.
POINT POINT POINT
After executing PLC reading, if the controller comment or comment capacity is changed, the
comment may not be correctly displayed on the FX ladder monitor screen.
When changing the comment or comment capacity, re-start the GOT.
4)
When comment is not displayed
When comment is displayed
ON/OFF status display for ladder monitor
ON status
OFF status
* The MCR command is normally displayed as
Description
13.4 Common Operation
:maximum 8 lines
:maximum 3 lines
.
13
13 - 11