Step List Window - Mitsubishi Electric GOT2000 Series User Manual

14.4.3

Step list window

Step list window displays the steps and transitions.
■1. Displayed contents
No. Item
1) Keys
2) Step display area
■2. Key functions
Key
1)
2)
Keys for operations on the step list window.
Displays the step/transition numbers and comments set in the step/transition.
Active steps are displayed in yellow, and waiting steps are displayed in red.
The locked step or transition is shown as below.
• Inactive : Gray
• Active : Pongee
• Waiting : Dark red
Touching the step or transition displays the step or transition on the SFC diagram monitor screen.
In addition, the program is displayed on the detailed program window. (When the step or transition
is locked, the authentication is needed on the password input window.)
The following shows the types of steps and transitions.
• Kn: Motion control step
• Fn: Once execution type operation control step
• FSn: Scan execution type operation control step
• GSUB: Subroutine call/start step
• Gn: Shift, Shift Y/N, WAIT and WAIT Y/N
• WAITON: WAITON
• WAITOFF: WAITOFF
Depending on the step/transition, the displayed contents of comments may be as follows.
• GSUB (Subroutine call/start step): Call destination/startup destination program name
• WAITOFF and WAITOFF: Bit device name
POINT POINT POINT
Precautions for changing the motion controller CPU to the debug mode
When MT Developer/MT Works2 changes the motion controller CPU to the debug mode, Shift Y/
N and WAIT Y/N in active status may not be highlighted in yellow.
Check the active status of Shift Y/N and WAIT Y/N with MT Developer/MT Works2.
Closes the step list window and displays the active step list window.
➠
14.4.4 Active step list window
Closes the step list window
Scrolls the display area up and down by one line.
1)
Display contents
Function
14.4 Operation Procedures
14
14 - 15