Access Range; Precautions; Operations For Display - Mitsubishi Electric GOT2000 Series User Manual

19.2.2

Access range

■1. For bus connection
With a single GOT, up to 2 CNCs can be switched for editing processing programs.
■2. For Ethernet connection
With a single GOT, up to 64 CNCs can be switched for editing processing programs.
19.2.3

Precautions

■1. Before using the CNC machining program edit
Carefully read the manual of the connected CNC and fully understand the operating procedures before using the CNC
machining program edit.
■2. Machining program edit protection
When the data protection key 3, edit lock B and C are enabled, the machining program edit is restricted.
Even when the data protection key 3, edit lock B and C are enabled, the machining program can be opened.
For the data protection key 3, edit lock B and C, refer to the following.
➠
■3. Software version of the CNC used
(○: Available, ×: Unavailable)
Software version of CNC
BND-1006W000-D6 or earlier
BND-1006W000-D6 or later

19.3 Operations for Display

■1. Start operation of the CNC machining program edit
The following explains how to display the CNC machining program edit screen after the GOT is turned on.
Step 1.
Turn on the power to the GOT.
Step 2.
Display the CNC machining program edit screen.
Use either of the following display methods.
• Starting from the special function switch (CNC machining program edit) set in the project
For how to set special function switches, refer to the following.
➠
• Starting from the utility
After the utility is displayed, touch [Monitor] → [CNC machining program edit] from the Main Menu.
For how to display the utility, refer to the following.
➠
19 - 2
19.3 Operations for Display
C70 Series Instruction Manual
Display of the machining program list
GT Designer3 (GOT2000) Screen Design Manual
GOT2000 Series User's Manual (Utility)
Function
○
○
Machining program edit
×
○