Mitsubishi Electric GOT2000 Series User Manual page 534

■3. Parameter setting operation
The following describes the procedure of changing the setting of the [Auto tuning] item as an example of the parameter
setting operation.
Step 1.
Select the item whose parameter is to be set with the item selection keys, and touch the [CHG] key.
Step 2.
As the parameter setting window appears, enter the parameter setting with the key window.
Touch the [Enter] key to confirm the setting.
To cancel the parameter setting operation, touch [×] at the top right of the screen to close the parameter
setting window.
Step 3.
As the confirmation window appears, touch the [OK] key to write the parameter setting to the motion
controller CPU (MELSEC iQ-R series).
To cancel writing of the parameter setting, touch the [Cancel] key.
Step 4.
After writing is completed, the parameter setting screen whose display has been updated to the new
parameter setting is displayed.
16 - 24
16.4 Operation Procedures