Mitsubishi Electric GOT2000 Series User Manual page 569

2) [CNC Chg] key
Switches the CNCs for monitoring when multiple CNCs are connected.
The switching order differs depending on the connection type used.
• For bus connection
The monitoring target is switched in order of the module number.
• For Ethernet connection
The monitoring target is switched in the order set in the Ethernet setting of GT Designer3.
3) [Rtn] key
Exits the CNC machining program edit and returns to the monitor screen or the utility of the GOT.
4) CNC device name
The display contents differ according to the connection type.
• For bus connection
Displays the CPU number and module name.
• For Ethernet connection
Displays the station number and module name.
5) Software key board
Used to input the machining program name.
Inputting [.PRG] in the CNC machining program name is not required.
For details of the software key board, refer to the following.
➠ ■3. Software key board
6) Capacity
Item
[Entry], [Remain]
[Character], [Remain]
7) Machining program list
Displays the CNC machining program list.
The machining programs are displayed in ascending order of the program numbers.
Machining programs are not displayed correctly if the program comment contains multibyte codes (such as
shift JIS codes).
8) Scroll key
Scrolls up or down the contents of the machining program list in increments of 10 or 50 items.
9) Message
Displays the guide or error messages.
For the details of error messages, refer to the following.
➠ 19.5 Error Messages and Corrective actions
10) Input section
Input a machining program name.
11) Menu
Item
[Open] key
[New] key
Displays the number of the programs registered as the user's machining programs and the
remaining number of the programs that can be registered.
Displays the number of characters registered in the user's machining programs and the
remaining number of characters that can be registered.
Opens an existing machining program.
When a machining program is selected or a machining program name is input in the input
section and the [INPUT] key is touched, the machining program is opened.
Jumping to the block number of a sequence number is enabled at the same time as the
machining program is opened.
Input characters in the "Machining program name/Sequence number/Block number" format
into the input section, and touch the [INPUT] key.
Example)
When jumping into the position of the sequence number 110 and block number 0 of 123.PRG
Input 123/110/0 or 123/110 in the input section and touch the [INPUT] key.
Creates a new machining program.
When a machining program name is input into the input section and the [INPUT] key is
touched, the new machining program opens.
Description
Description
19.4 Operation Procedures
19
19 - 5