Signals - ABB Relion Technical Manual

Section 16
Station communication
16.6.4
16.6.5
Table 474: GOOSEINTRCV Non group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
16.6.6
650

Signals

Table 472: GOOSEINTRCV Input signals
Name Type
BLOCK BOOLEAN
Table 473: GOOSEINTRCV Output signals
Name Type
INTOUT INTEGER
DATAVALID BOOLEAN
COMMVALID BOOLEAN
TEST BOOLEAN
Settings
Unit Step
- -
Operation principle
The DATAVALID output will be HIGH if the incoming message is with valid data.
The COMMVALID output will become LOW when the sending IED is under total failure
condition and the GOOSE transmission from the sending IED does not happen.
The TEST output will go HIGH if the sending IED is in test mode.
The input of this GOOSE block must be linked in SMT by means of a cross
to receive the integer values.
The implementation for IEC61850 quality data handling is restricted to a
simple level. If quality data validity is GOOD then the DATAVALID
output will be HIGH. If quality data validity is INVALID,
QUESTIONABLE, OVERFLOW, FAILURE or OLD DATA then the
DATAVALID output will be LOW.
Default Description
0 Block of function
Description
Integer output
Data valid for integer output
Communication valid for integer output
Test output
Default Description
Disabled Operation Off/On
1MRK 502 048-UUS A
Technical manual